Hey Everyone,
I'm looking for a roof rack to be built for my Toyota 4Runner. The structure will primarily be built out of 1" HREW tubing. Similar to the standard Baja/Gobi racks out there, but different dimensions. Below is an image of a similar product to what I'm looking for. If you're...
Does anybody have a good recommendation for a zippered binder for a LR data book? Looking for a 3 ring 8.5"x5.5". I was thinking maybe find a planner-type binder but nothing's really fitting the bill. I also don't want to buy a $40 "pre-made" data book just to toss the bulk of it out. Ideally...
Has anybody heard from Ed recently? He last sent me a message about a week ago but haven't heard since - I've got a group ready to go and hoping to get a date set.
Is there a ballpark cost per group? Obviously not as discounted as last year, but if it's even remotely in the ballpark I'd be interested.
Sent from my iPhone using Tapatalk
Buddy and I were down in Rapidan WMA in VA today from 0400-1630. Not a single deer. We've been trying different spots over the past couple years but still no luck.
No worries, figured it couldn't hurt to get a couple more heads thinking it over.
Ya, it's within spec. The only reason I expected it to be slimmer was because my understanding is that it was supposed to fit in the Wilson "new" 308 case holder. I'll pick up the "fired" holder, just wanted to...
I've got a Redding FL type S die (.308) that I started prepping brass with. I've got a Wilson case trimmer with the "new" 308 brass case bushing per Wilsons information (full length sized brass uses the same bushing as new). When I slid the brass into the bushing, it didn't fit.
Long story...
If anyone from class 6 is looking to switch to class 5, please let me know. I can still make 5 if necessary, but would like a little more time to prep if possible.
I'm about to pick up a Springfield 87 from a buddy of mine for practically free due to it always jamming on him. Are they picky about ammo that leads to jamming also, or anything else that are known trouble areas with em?
Note I wasn't talking about slacking off. But for example I'm not going to hand weigh every charge of 9mm as I would 308, or bother with picking up match grade bullets for .223 if I'm just going to use it at the range, etc. not so much cut corners on the basic process.
Sent from my iPhone...
I think my debate on what provides the most benefit comes in primarily in regards to brass prep. Neck sizing, tension, etc. to me strikes as the more important of the processes while I haven't gotten too involved with things like annealing and truing primer pockets yet.
Sent from my iPhone...