So I have a M&P 9 1.0. It does NOT have an optic cut, and I don't have the funds to purchase an optics cut slide. So I was going to purchase a plate adaptor that sits in the rear sight slot.
That being said, does anyone actually co-witness and use their irons with MRDS installed? I am debating between different MRDS and the primary factor I am looking at for the moment is MRDS with built in sight notches to replace the rear sight.
Folks with the MRDS, have you found this to be an issue? Or does it not matter?
Specifically I'm looking at the CT RAD Micro ( Amazon product ASIN B08Q386V5J )
That being said, does anyone actually co-witness and use their irons with MRDS installed? I am debating between different MRDS and the primary factor I am looking at for the moment is MRDS with built in sight notches to replace the rear sight.
Folks with the MRDS, have you found this to be an issue? Or does it not matter?
Specifically I'm looking at the CT RAD Micro ( Amazon product ASIN B08Q386V5J )