JWBanshee
Active Member
- Jul 1, 2009
- 399
Built a SBR, 10.05 DD barrel, and Gas block. I used a pig tail gass tube, it coils arouind the barrel. RRA lower, standard buffer and spring, and a Pig on it.
I shot the gun yesterday, It would shoot 3 rounds, then not load. it did this on and off. After spraying rem oil and gettingh eveything lubed up I managed to get it to shoot too mags completely. This is a new build, so I was just braking it in. I di notice the Feed ramps were full of crud and this could be part of the problem. Would polishing thje ramps help. Also I was shooting UMC ammo. On another note I also shot My Noveske Build, it ran flwlessly, even the 100 round drum. It made me smile.
Any Ideas on the SBR.
JW
I shot the gun yesterday, It would shoot 3 rounds, then not load. it did this on and off. After spraying rem oil and gettingh eveything lubed up I managed to get it to shoot too mags completely. This is a new build, so I was just braking it in. I di notice the Feed ramps were full of crud and this could be part of the problem. Would polishing thje ramps help. Also I was shooting UMC ammo. On another note I also shot My Noveske Build, it ran flwlessly, even the 100 round drum. It made me smile.
Any Ideas on the SBR.
JW