gibby
Ultimate Member
Looking into suppressing a Beretta 92. Any recommendations on who does good barrel threading for suppressors?
I ran across this site when I was looking into getting my RRA 9mm barrel cut and threaded. I remember reading postitive things about them.
http://www.tornado-technologies.com/services.html
Your can may be a bit too heavy to cycle the slide without a neilsen recoil device. A lighter recoil spring should resolve that issue.
Just make sure to change it out to the standard spring when firing the gun unsuppressed.
Thanks for the reply.
I believe the standard is 13lbs, any suggestions on how light?
Almost everyone runs 1/2-28 on their 9mm Berettas, why the metric LH threads?
Almost everyone runs 1/2-28 on their 9mm Berettas, why the metric LH threads?
Most European pistols use the 13x1LH Metric thread pattern. ( HK, SIG)
The threads als tend to keep the can tight on the pistol, as the rifling twist causes them to tighten up.
I has Tornado Technologies thread my M9 barrel 13.1LH to make it compatible with the Trident that I use for my HKUSP9SD