Speedluvn
Active Member
What bullet puller will you use?
Set up a new bench in the basement.
And then I promptly cluttered it up.
What bullet puller will you use?
Just a cheap kinetic hammer from Amazon. I want to get the Hornady Cam Lock or RCBS puller die but neither come with the collets and finding everything on the same site for reasonable prices wasn’t working. Figure I’ll use the oven hammer and buy one of the others later even if it’s piece by piece over some time.
Open to other suggestions though.
I too am looking for a bullet puller for rifle rounds that have been crimped.
I too am looking for a bullet puller for rifle rounds that have been crimped.
What size do you need?
I got one of these for using in the press.
I pulled about 500 8mm mauser and now I"m pretty much done with it.
The Mauser rounds had a heavy crimp on it and I put grip tape on the handles to not hurt my hands
https://www.amazon.com/GRIP-N-PULL-Large-Bullet-Puller-Calibers/dp/B01BU9MXHM
Can't wait to put some shelves up, and then immediately fill them up toothat's funny, was my first thought
The only good way to pull these with a kinetic puller is to first push the bullet into the case to break the seal. You can do this with your seating die. Then they will come out easy when you play "Whack a mole."
This!
Also, I don’t play whack a mole. I press the kinetic puller against a pneumatic palm nailer. Bbbbrrrrrrp... bullet out.
Now that truly is American ingenuity. That has to be the first time I have ever heard of this.
I put the turret press on a short length of a 2x6 so I could move it out of the way easily for other work. I used the Lee mounting plate to also be able to exchange the single-stage and turret on the same moveable platform.
]
Started prepping another thousand rounds of 556. 4,000 down, 14,000 to go
Finished off the last of my 4lb of Ramshot Competition today and tossed the last 2.6gr into the garden. I've been happy with this powder for my lead SWC 1911 loads.