funnsun34
Member
So have a built a few 80% anodized lowers with my ghost gunner.
The ghost gunner does a great job, however it could use a little clean up in the pocket. I was wondering if anyone on the gunsmithing thread would have a recommendation on buffing the pocket, probably with a drill press. The next lowers I'm going to built will be non-anodized I basically want the pocket be as smooth as the outside of the lower before airbrushing with Duracoat.
thx
The ghost gunner does a great job, however it could use a little clean up in the pocket. I was wondering if anyone on the gunsmithing thread would have a recommendation on buffing the pocket, probably with a drill press. The next lowers I'm going to built will be non-anodized I basically want the pocket be as smooth as the outside of the lower before airbrushing with Duracoat.
thx