Sig P320 M17 out of jail

[jrumann59]

So my Not Disappointed came in this morning. I proceeded to JLowes to pick up the new toy. 1st pictures us it unmolested with factory sig grip module. The factory grip module is not terrible the stippling on it is more akin to 1st gen M&P9 which i loved but not a lot of it.


2nd pic is of the factory grip module side by side with Wilson Combat grip module. Not quite a match for Sig FDE but once on the gun it definitely shows the coyote slide side note WC grip has slots for tungsten rods if you get it you will need to either silicone the rods in or put a singer wrap of electric tape on the thinner rods and double wrap on the fatter rods so your sig does not become a rattle.

3rd, 4th and 5th pictures are the grips on a scale. 3rd is the sig grip at 3.5 oz, 4th is WC with all 3 tungsten rods at 4.8 and 5th is the WC with no tungsten at all at 3.3 oz

Last pic with the WC grip module installed it has nice stopping everywhere a little aggressive on the f4ont and back strap that is M&P 2.0 rough but not too bad.

I will try and get to the range tomorrow. The trigger is as advertised by other youtube reviewers. A little take up to nice hard wall then breaks, reset is a little mushy with decent amount of travel to get to.

 

[Gcs7th]

I like the Wilson grip module.

 

[jrumann59]

It is much grippier than the original Sig module. Magwell is much nicer as well less things to hang up on. I am going to put a couple hundred more rounds through it to see if the trigger gets better the reset is meh.