Chrsnel
Member
I have been replacing parts on my xdm 40 so I have punches and stuff. if I do the glock clone are there any must have tools...
I have been replacing parts on my xdm 40 so I have punches and stuff. if I do the glock clone are there any must have tools...
In additional to the tools used to mill the lower, I believe you will need:
Glock Channel Liner tool
https://www.midwayusa.com/product/1019380245/swenson-glock-channel-liner-tool
Front sight tool
https://www.midwayusa.com/product/1007071416/glock-screw-on-front-sight-installation-tool
3/32" or 2.5 mm punch
.
I stand corrected. I agree that a front sight wrench is really needed, too. It is almost impossible to tighten the sight screw enough, without it. The channel liner can be installed properly without the channel liner tool, though. I use a punch that happens to fit perfectly into the channel. A few light taps is all it takes.