Gun is Springfield XDm compact Elite.45Looking to change my Hex Dragonfly W/3.5 moa dot. It’s a little small would like something near 6moa any suggestions. Adapter plate help as well.
Holosun 407k is a 6 moa dot and fits nicely on my P365.Looking to change my Hex Dragonfly W/3.5 moa dot. It’s a little small would like something near 6moa any suggestions. Adapter plate help as well.
$100 +/-What would be the typical/common price that I should expect to pay a local gunsmith to mill the slide of a glock so an RMR could be installed --OR-- is it just cheaper to buy the MOS version from the get go?
There aren't many local gunsmiths that are doing these and you will probably wait longer than if you sent it to one of the machinists advertising online.What would be the typical/common price that I should expect to pay a local gunsmith to mill the slide of a glock so an RMR could be installed --OR-- is it just cheaper to buy the MOS version from the get go?
I just sent out the slide for a Springfield XD-M to be milled, it was $150 but also you've got shipping on top of that. You can find some doing it for even cheaper, BUT, the more expensive service recreates the exact same cut from the factory and thus uses the factory adapter plates. The cheaper are more simple and improvised and require using shortened springs, etc...What would be the typical/common price that I should expect to pay a local gunsmith to mill the slide of a glock so an RMR could be installed --OR-- is it just cheaper to buy the MOS version from the get go?