blksniper2000
certified lurker
Ok so i put together a AR pistol using a spikes lower, psa 10.5 cold hammer forged upper, psa lower parts kit, wmd nib bcg, and a phase 5 pistol buffer tube assembly kit.
So the first time firing it at the range i load a mag, fire it once and the bcg gets stuck while feeding the second round. the hammer does not reset and the round was not fully seated in the chamber. I was unable to pull the bcg back to clear it, I had to actually use my ar wrench to take off the buffer tube to release pressure from the spring, next separate the upper from the lower, then take a small hammer and tap the bcg forward a few millimeters to chamber the round, put it back together and fire it to clear the round.
I took it home and cleaned it then tried it on another day, I made it through maybe 4 or 5 rounds and the same thing happens again, I had to repeat the same steps to clear it.
Any thoughts or ideas?
So the first time firing it at the range i load a mag, fire it once and the bcg gets stuck while feeding the second round. the hammer does not reset and the round was not fully seated in the chamber. I was unable to pull the bcg back to clear it, I had to actually use my ar wrench to take off the buffer tube to release pressure from the spring, next separate the upper from the lower, then take a small hammer and tap the bcg forward a few millimeters to chamber the round, put it back together and fire it to clear the round.
I took it home and cleaned it then tried it on another day, I made it through maybe 4 or 5 rounds and the same thing happens again, I had to repeat the same steps to clear it.
Any thoughts or ideas?