Rregdab
Active Member
Need a little help here.
I'm thoroughly disassembling a P38 for cleaning and can't figure out how to get the trigger connector plate off. In step 10 in this procedure http://www.waltherforums.com/forum/faq-classics/13558-how-disassemble-p1-p38.html it looks simple. I can't see how this is possible without bending the plate.
Any advice would be greatly appreciated!
I'm thoroughly disassembling a P38 for cleaning and can't figure out how to get the trigger connector plate off. In step 10 in this procedure http://www.waltherforums.com/forum/faq-classics/13558-how-disassemble-p1-p38.html it looks simple. I can't see how this is possible without bending the plate.
Any advice would be greatly appreciated!