Scrounger
Active Member
How much interest is there in 300 blackout?
The reason I ask is there was a thread about procuring some 5.56 brass to have it converted in another thread and I didn’t want to hijack it.
The question is if I tooled up to convert 5.56 to 300BO would there be any interest in it.
Other than a trim die and probably another trim motor for convenience, I have everything necessary to complete the task.
Brass is not a problem; I probably still have over 400M once fired military. I can clean 8M at a time. And depending on how fast I run the press it looks like I could convert at least 1M an hour.
I have something going on at this time that will prevent me from getting started till after the holidays. So, I have time to research the topic.
The reason I ask is there was a thread about procuring some 5.56 brass to have it converted in another thread and I didn’t want to hijack it.
The question is if I tooled up to convert 5.56 to 300BO would there be any interest in it.
Other than a trim die and probably another trim motor for convenience, I have everything necessary to complete the task.
Brass is not a problem; I probably still have over 400M once fired military. I can clean 8M at a time. And depending on how fast I run the press it looks like I could convert at least 1M an hour.
I have something going on at this time that will prevent me from getting started till after the holidays. So, I have time to research the topic.