Grumpy41
Active Member
Finally received my Asbury from Stock Stocks. I can say for the money I was a bit disappointed in the following;
1. The rear stock was lose, which should have been caught at the factory. Not a big deal as I had to remove the connector joint, drive out a pin, remove the bolt to get to the screw.
2. My AI mags are so tight it will take both hands to remove, they do not drop freely like the single supplied mag. My mags work and drop freely in my Surgeon BM. Contacted Asbury and they said I may need to flair the opening some more--BS for that. Guess SAC will have see what they can do.
Other than the above it is nice looking and feeling stock, of which will most likely not improve my shooting ability but will look good. LOL
Now the continuation of the wait for the completed build.
1. The rear stock was lose, which should have been caught at the factory. Not a big deal as I had to remove the connector joint, drive out a pin, remove the bolt to get to the screw.
2. My AI mags are so tight it will take both hands to remove, they do not drop freely like the single supplied mag. My mags work and drop freely in my Surgeon BM. Contacted Asbury and they said I may need to flair the opening some more--BS for that. Guess SAC will have see what they can do.
Other than the above it is nice looking and feeling stock, of which will most likely not improve my shooting ability but will look good. LOL
Now the continuation of the wait for the completed build.