Pwilliams1
Active Member
- Apr 25, 2013
- 665
I recently finished an ar build, everything works as intended, but the upper and lower are extremely tight. Tight enough that I have to use a hammer and punch to get them apart. None of my other rifles have been this difficult to disassemble. All rifles are built on stag uppers and lowers. I'm wondering if this could cause any wear issues long term.
I'm probably a little over concerned because this is a pre ban lower, I want to make sure I don't damage it unnecessarily.
Other uppers fit fine on this lower, so I think the issue is coming from the upper side. Should I leave it alone, or have someone look at it?
I'm probably a little over concerned because this is a pre ban lower, I want to make sure I don't damage it unnecessarily.
Other uppers fit fine on this lower, so I think the issue is coming from the upper side. Should I leave it alone, or have someone look at it?