anodizing an 80% lower

[tmak67]

Has anyone had their 80% lower professionally anodized?

 

[jkeys]

Has anyone had their 80% lower professionally anodized?

Yes... I used a shop in PA called M&Z anodizing and sent the lowers along with a bunch of work parts and they did them for free , otherwise they charge $50 minimum up to a few dozen parts. They are horrible at answering the phone or email and do much better with walk-ins. You could also try Eastern Plating in Rosedale, they do solid work on the stuff for my job, but I'm not sure if they are gun friendly or not.

 

[dontpanic]

Yes... I used a shop in PA called M&Z anodizing and sent the lowers along with a bunch of work parts and they did them for free , otherwise they charge $50 minimum up to a few dozen parts. They are horrible at answering the phone or email and do much better with walk-ins. You could also try Eastern Plating in Rosedale, they do solid work on the stuff for my job, but I'm not sure if they are gun friendly or not.

Do you have a link or a phone#.?Address or anything?
It would be greatly appreciated.

Just found them:
http://m.yp.com/dallastown-pa/mip/m-z-anodizing-6529643
Less than 30min for me.

 

[ROBAR35]

I've had Eastern Plating on Pulaski Hwy. do 2 AR-10 lowers and they turned out awesome.

 

[tmak67]

Did you have to have your lowers with engraved with serial numbers, location of manufacture...etc?

 

[CXD Arms]

Subscribing for more info

 

[Fox123]

So did you get it annodized before you finished it? May just be crappy picture but those holes look annodized as well.