ViperRy
Active Member
I'm building a new reloading bench. Anyone know where to find some 1" or 1-1/4" MDF boards in MD? I know Homie Depot sells 1/2" and 3/4" and I could laminate 2 pieces together, but I was hoping for one solid piece.
My plan was for a a 1" MDF with 1/2" plywood on top so I can replace it when I need to. Sorry i didn't state that in the op.
If you disregard the suggestions and go ahead with your thick MDF, that stuff is friggin' heavy. I hope you have some big friends.
..again, original plan was plywood topping the MDF. Read the whole thread. Thanks for all the responses. I'll mostly likely go with 2 pieces of plywood. Bench is going to be 7'x2'8" with shelving and peg board at the rear. 2 presses mounted on the top.
..again, original plan was plywood topping the MDF. Read the whole thread. Thanks for all the responses. I'll mostly likely go with 2 pieces of plywood. Bench is going to be 7'x2'8" with shelving and peg board at the rear. 2 presses mounted on the top.
I would go larger I have similar bench setup and 36X80 gets crowded quickly.