PowPow
Where's the beef?
I went over to inlinefabrication.com to see what's new. I picked up some of these for my 550:
All done except the bench top organization. I’m sure it will take some time to find what works best.
Brass on the bottom shelf, bullets on the top and the inline fabrications plates make it so easy to switch from press <> vise
Starting over fresh! In the process of finishing our basement so I framed off a 14x8 man cave/reloading room. Used 3/4" red oak as my bench top reinforced with 2x3 attached directly to the studs. Wired in 5 outlets so I always have places to plug stuff in if needed. Next will be some vinyl plank floors and more overhead lighting.
Are you going to put rolling storage below, fixed shelve(s) below, or mix of both?
Finished up case prep work on almost 700 .45ACP cases.