While we are on this topic, any specific thoughts on the unistrut jig? I have enough length I was planning to cut two sections specific to the length of the g3 (which will be just silly in pistol configuration) and mp5. I’m welding a six inch section to the ends 90* to the main length for the 20mm rod to ride in vertically, and using 1/4 all thread through the alignment holes in the flats.
I also have the 3D jig fully printed for cetme size receivers and am printing an alternative half today that will make the jig align with mp5 holes. I have seen positive reviews of both methods, but in the off chance anyone has tried both and can give a comparison of pros/cons....
I also have the 3D jig fully printed for cetme size receivers and am printing an alternative half today that will make the jig align with mp5 holes. I have seen positive reviews of both methods, but in the off chance anyone has tried both and can give a comparison of pros/cons....