https://www.sb-tactical.com/product/lopl-length-of-pull-limiter/
Anyone have any of these? I need one to limit the LOP of an SBA4 brace for an AR pistol that has a Law Tactical Folder. Fully extended would result in about 14in LOP which is a grey area for ATF since it's over 13.5
They've been sold out for a while. Blocking the last position should put me a hair under 13.5 fully extended so I will be G2G.
I'd prefer not to take JB weld to my buffer tube. I've seen some schematics online for 3d printed versions, but don't have access to that either.
I know the 13.5 LOP isn't "rule of law", but since this is a dedicated HD set up, I wan't to be overly careful and leave no room for questions.
I prefer this method because it's a product developed by SB, for SB braces, who have done their due diligence with the ATF.
Anyone have any of these? I need one to limit the LOP of an SBA4 brace for an AR pistol that has a Law Tactical Folder. Fully extended would result in about 14in LOP which is a grey area for ATF since it's over 13.5
They've been sold out for a while. Blocking the last position should put me a hair under 13.5 fully extended so I will be G2G.
I'd prefer not to take JB weld to my buffer tube. I've seen some schematics online for 3d printed versions, but don't have access to that either.
I know the 13.5 LOP isn't "rule of law", but since this is a dedicated HD set up, I wan't to be overly careful and leave no room for questions.
I prefer this method because it's a product developed by SB, for SB braces, who have done their due diligence with the ATF.