Occasionally I have a problem when the bolt is retracted and open and insert a magazine and press the bolt release, the bolt will close and the trigger will fire, but no ignition. The charging handle and bolt become stuck in the closed position. I have to rap the stock to clear the shell and...
Has any one had any experience with Anderson Mfg Ar15's ? Their web page is quite impressive. They say that the RF85 process will allow their firearms to run dry (without oil), most important how is their MOA. Any comment would be appreciated.
Thanks
Has any one had any experience with Anderson Mfg Ar15's ? Their web page is quite impressive. They say that the RF85 process will allow their firearms to run dry (without oil), most important how is their MOA. Any comment would be appreciated.
Thanks
I'm thinking about another AR upper with a 1 in 7 twist. Does anyone have any comments or suggestions concerning bullet grain weight for this particular rate of twist? Thanks!
I recently bought some Remington 30 cal 165 gr Accutip from Midway. They came in a sealed Remington Box. I never checked the grain weight and loaded some using data from Hodgdins (CFE 223). Shot one and the case would not eject from my bolt action rifle. I had to use a rubber mallet to get...
HAS ANYONE USED A HEAVY BUFFER 4.2 oz (tungston powder filled). I READ SOME ARTICLES LATELY OF HOW BOLT BOUNCE IS ELIMINATED. I'M WONDERING IF A STANDARD BUFFER CAN BE FILLED WITH TUNGSTON POWDER BY REMOVING THE ROLL PIN AND STOCK WEIGHT AND REINSTALLING THE POLYMAR BUSHING IN THE END AND ROLL...
I'm looking for reloading data for the above plated bullets for 40 cal S&W.
How much should I reduce the powder charge using plated bullets vs. FMJ?
Any info would be greatly appreciated. I generally use Winchester 231 powder.
Hi:
Pardon my ignorance, the HBAR Colt has a large pivot pin. Is there a pin made to accept a lower with a .250 Pivot pin hole? Or is this an area to be left alone due to possible excessive wear?
Thanks
I've seen a lot of info on minimum and maximum lengths for .223 brass. To put it buntly...I'm getting confused and what to believe. Any help would be appreciated. I'm loading Lake City and currently using 1.750 or 1.753
Thanks!
Has anyone had any hands on experience with Springfield's XDs, I'm reaIly interested in this handgun...I'm partial to 45's ...1911's (have Colts). I'd like any comments!
Thanks!!
The shotgun points and shoots well...no complaints. Does anyone know of a shell catcher for this shotgun? It really kicks out fired shell...not too friendly on the trap range. looking for a solution!
About 2 months ago I picked up some Lucas Gun Oil. Lucas stated it is heat resistant, water resistant, and odorless. I've used it and am very pleased with the results on my 1911...seems to resist burnoff. They say it neutralizes acids caused by human hands. I'm very satisfied with this...