I hadn't seen this before (public school education). 2,400 years old but it succinctly addresses gun control laws.
"Good people do not need laws to tell them to act responsibly, while bad people will find a way around the laws." - Plato
My gun club is hosting W&C classes in October. The class size is limited to 40 people.
When I ride by a local place offering classes on the weekend, I see maybe 15 vehicles in the parking lot.
What is a normal size class? Or maybe more importantly what is the typical trainer to student ratio?
One person injured and "significant damage to the house"
https://www.eveningsun.com/story/news/2020/10/30/package-explodes-maryland-neighborhood-damages-house-injures-2/6094357002/
I searched but couldn't find what I was looking for.
Once the anodized 80% lower is completed, do you put a finish on the bare aluminum? If so, do you paint the pin and selector holes or does the coating make the holes too small?
What is a good DIY coating (e.g. DuraCoat, AlumaHyde)...
Wow coming from the Bloomturd school. They even played with the data.
https://www.breitbart.com/politics/2020/02/18/johns-hopkins-study-no-evidence-assault-weapon-bans-reduce-mass-shootings/
Yesterday, I noticed that all air pistols were on clearance at Hampstead for about 40% off. Today, at Cockeysville, they were 75% off. There was a Beeman air rifle with scope for $19 (originally $79) but the other rifles had not been marked down.
Is there any reason a lower has a set screw hole on both of the front ears for the trigger guard instead of just on the right side?
Is there some tacticool part that I'm not aware of that requires a hole on both sides?
When I put I'm my Magpul trigger guard, the left side is going to look...
I just saw this. Defective heat treating could lead to barrel rupture. Affects a limited number of the Glock 17 version.
https://recalls.keltecweapons.com/
More evidence of Liberals' distane for there supposed constituency.
http://www.foxnews.com/us/2017/07/20/concealed-handgun-permits-surging-blacks-women-lead-growth.html
Chris Cavey, Deputy Secretary of Appointments, will be having his annual pig roast. Larry Hogan will be attending again this year. Last year, was a sell out with a number of MDS members in attendance.
For those attending the MDS Pig Roast on the same day (8/5), this one doesn't start...
I saw this article on a kit to eliminate the latch from a factory charging handle.
http://www.thefirearmblog.com/blog/2017/03/09/finally-making-base-ar-15-charging-handle-ambidextrous-sintercores-xrs/
Does anyone have experience with this or Sintercore's Tripwire charging handle? It might...
I'd like to do a couple of 80% lowers. I plan on using the 80% Arms Easy Jig. I could order everything directly from 80% Arms but I prefer to support local IPs whenever possible.
I'm looking for black anodized, forged lowers and the Easy Jig with the extra cost steel bushings. Getting...
All the pictures I've seen show a small laminate trimmer being used. I have very nice full size router and other than being heavier I don't see a problem. Any issue using a full sized router?
For $20 extra, they offer hardened steel drill bushings. I usually spend the extra money for heavy...
Father was a prohibited person but somehow got past NICS check. Son used illegally obtained gun in shooting.
http://www.usatoday.com/story/news/nation/2015/09/29/father-wash-high-school-shooter-found-guilty-gun-charges/73058328/ ://