Like this?
18" barrel .308 upper on the gun.
24" barrel 6.5cr upper below it.
Proof Research barrels
Lancer systems hand-guards.
Syrac ordinance Adjustable gas blocks
Witt Machine MRE muzzle breaks
And
only ONE BCG JP Low Mass
The Ranges were deeded over to MD-DNR in that 1990ish timeframe mentioned above.
There were 4 clubs grandfathered in to use of the range as part of the deal
Meade Rifle and Pistol Club.
Meade Rod and Gun Club
Maryland State Rifle and Pistol club
Meade Natural Heritage Assoc.
only MRPC and...
I take it from your choice of Indoor ranges that you might have something to do with DoD in the area of Fort Meade.
we might want to have a PM conversation.
Curtis was one of the old school Kitchen Table FFLs. He always had the best transfer prices.
I was upset with him too when this article came out but he was also always a bit of a Fudd.
Curtis sold out to Martin who is open in a new location and I have had one flawless transfer through him...
By the way......I'm waiting for someone to do a test of these https://ebrammo.com/762-x-39mm for Ballistics and ME.
I suspect it will make all the .300AAC fanboys cry.
This post seems to assert that the round itself is inherently less accurate.
I'd go along with this if the assertion was that the stamped and folded receiver commie guns that 7.62x39 was designed for are less accurate, but the round itself...naahhhh.
I think this link to another forum is...
IIRC the silent captured buffer spring came with a white plastic (delrin?) spacer I think that is inside there
I’ll pull it apart and refresh my memory
The stock is fine it’s not a great cheek weld but I do ok with it
Sent from my iPhone using Tapatalk
This Build started with a pre-FSA2013 on what the desirable parts would be for an AR-10 and then an offshoot discussion of the Christensen Arms Recon-10 and lightweight DMR rifles in General.
Parts list
Mega Arms MATEN reciever set and extra Upper.
Proof Research 18" .308 barrel
Proof...
I'm in with 76 and since sharing with 44man is the thing to do...I'll split it with him for the low low cost of showing me some smelting and casting tricks. I have a 45 mold I've not used yet.