For the OP in FA, I'd recommend the MK9K. It's what I run on my M11A1. I'm no expert, but I think the extra volume helps reduce blowback on FA open bolt guns.
It is not a small can. You will not want to put it on a pistol unless you have VERY tall sights and VERY strong wrists. ;)
Like...
Andrew. I see your black and FDE .308, and raise you a full FDE .308 with nightforce scope. It was strange being in 2A today without you showing up.
The colors actually match much better in than they look in the picture. I blame bad lighting combined with cell phone camera.
Thanks to all...
I'm still confused about SBRing a receiver owned prior to 10/1 that would be a copycat (<29"). According the advisory it would still be a copycat, but would it be grandfathered? Which date matters? Date of acquisition of the receiver or date of conversion to SBR configuration? It's as clear...
Currently a toss up between the PS90 SBR and RFB. If the Geisele trigger for the Tavor turns out to be as much of an improvement as I hope then I'll probably prefer the Tavor.
I finally decided what I want in an AR-10... and it's this. I'm going with the stainless finish barrel though. Otherwise it'll be pretty much the exact same build. I started getting the parts from 2A today.
JT - Will be keeping you in mind for service on my SLK. Haven't been happy with dealer service.
Do you do or can you recommend someone who does body work on mercedes? I managed to back the SLK into my SUV in the driveway while in a hurry to leave one morning. Trailer hitch punched a hole...
I've been accumulating the parts from 2A for this build over the last few months. It's finally finished. Assembled the lower myself from a stripped lower I bought before the ban. It has full ambi controls since I'm a lefty. 2A built the upper for me from parts I bought there.
Thanks Mark and...