If you want to go cheap, the 10mm/45 size glock factory holster fits the g17 frame p80 damn near perfectly. I either did nothing or some light buffing on mine, cant remember.
Definitely not as nice as what others are showing but you can usually get them for $12 or less online.
What a great idea! I've ordered the "GLOCK Sport Combat Holster" for $12.12. I'm curious to see what the fit and retention will be like.
For those interested in a cheap OWB holster option - the factory Glock Sport Combat holster works with these pretty well!
I ordered the larger one (for .45/10mm) after reading a few posts saying that the P80 frames usually require larger holsters and the G17 P80 frame clicked in well. There is a little bit of top end slop but just a tiny bit (a lot less than putting a gen 4 G23 in there). Can flip it over and shake it pretty hard without the gun coming out.
*Edited to add* - if you decide to get one of these, definitely get the large frame one because once it's on your belt, the retention tightens up a bit (as the plastic is soft/pliable). Mine is on the tighter side of "good" retention once on my belt. That leads me to believe that the smaller frame holster would definitely be too tight.
Best part is that it was only ~$12 shipped from Amazon here. Good reviews and quite a bit of mod options out there on youtube.
Note that I have the extended mag release so I did cut out a little channel in the plastic to accommodate that. It did fit stock but there was enough pressure on the mag release that just a little more would cause the mag to drop. Cutting the plastic was easy with a knife - just a few minutes of time to complete.
After watching a few YT vids, I took a lighter to the belt "flaps" of mine and molded them inwards to be more contoured to my body. Quick and easy to do!
So you can't use a regular glock 17 holster because of the rail on the P80's, right?
So you can't use a regular glock 17 holster because of the rail on the P80's, right?
You got the 10mm/45 size, correct? You need the larger frame holster for the way that the p80s are designed.
I just looked and i didnt have to modify anything. I did a tiny cutout for the extended mag release and put heat on the belt attachment areas to mold it more to my body.
Yes, I got the larger one.
That's good news you didn't have to modify anything. I used the standard mag release given the indented area on the P80. So I might not even have to make the cutout.
What do you use to apply the heat? I've heard of using a butane torch but that there are better ways.
I don't know about the full size but the alien gear glock 19 shell fits the PF940C just fine.