Question 2: I am decapping and priming on my turret press. Right now I decap/full length size, take the cases of the press to trim and deburr, then return to the sizing die to prime. That means all cases go through the sizing die twice, raising the potential to overwork the brass. Is it safe to prime on the downbstroke after charging the case? I have never had a primer go off while seating, but anything can happen.
Question 2: I am decapping and priming on my turret press. Right now I decap/full length size, take the cases of the press to trim and deburr, then return to the sizing die to prime. That means all cases go through the sizing die twice, raising the potential to overwork the brass. Is it safe to prime on the downbstroke after charging the case? I have never had a primer go off while seating, but anything can happen.
Depending on powder type and flash hole size, you’ll make a big mess as the powder pours out through the flash hole.