MEGARMS
KnowNothing
Don't do this. Too many problems with compensators breaking, cracked slides, etc.
No worries. If I were to buy/build an open gun, it would not be an STI.
Don't do this. Too many problems with compensators breaking, cracked slides, etc.
STI ("Stacatto") is out of the race gun market anyways and is focused on the duty/tactical crowd. Atlas, BUL, and Infinity are the big players there nowadays, short of buying a true custom piece.No worries. If I were to buy/build an open gun, it would not be an STI.
STI ("Stacatto") is out of the race gun market anyways and is focused on the duty/tactical crowd. Atlas, BUL, and Infinity are the big players there nowadays, short of buying a true custom piece.
https://www.vulcanmachinewerks.com/optic-cuts
Not local, but I believe Sti will still keep the factory warranty if you get the milling done by Vulcan.
Well, got the old sight out however the mount is not tight enough. I was able to push it in with my fingers. It came with a set screw but there is nothing in the slide to screw it into.
Back the the drawing board I guess.
I don't think that the set screw is meant to go into the slide. It just pushes on the slide and pushes the sight plate up into the dovetail tightening it.
I wonder if they sent you the wrong plate. I was looking into the same type of solution for my STI Edge.