davsco
Ultimate Member
so my first poly80 glock, done a handful of ar15's & 10's. hard to tell with the pics, but the rear trigger block and the poly80 rear block seem to be tilting up just a bit in the front. the trigger bar seems to be higher than in my oem glock. as a result, i have to really press down on the ejector for the slide to come all the way back (ie the ejector is blocking the slide coming back because it is sitting a little high/angled up).
it is very hard to rack. i think in part from the ejector rubbing on the bottom of the slide and the rear rails not being parallel to the front rails. i don't see the slide rubbing on the frame. the lower parts are an oem glock kit.
i've just emailed p80, but if you see anything obvious or have any suggestions, i would appreciate that info. thx, david
it is very hard to rack. i think in part from the ejector rubbing on the bottom of the slide and the rear rails not being parallel to the front rails. i don't see the slide rubbing on the frame. the lower parts are an oem glock kit.
i've just emailed p80, but if you see anything obvious or have any suggestions, i would appreciate that info. thx, david