Modifying an Uzi Barrel

Expendables · Mar 2, 2019

Hey guys need a little help here. I purchased this 8.5 inch semi auto barrel for my semi auto vector and the barrel band that is circled in the middle is preventing the barrel from fully inserting into the trunnion of my Uzi. What would you recommend to sand/shave down the barrel band in the middle so that my barrel fits? I’m not worried about cosmetics the only time I’ll look at it is when the gun is cleaned.

Thanks!

jjones88 · Mar 2, 2019

lathe if if you have one. If you don't you could use a grinding wheel if you have a really good touch.

Other option is old school and to chuck it up in a drill press and use emory cloth.

So:

1. Lathe
2. Emory cloth with it slowly rotating
3. Grinding wheel

Most likely can cold blue it or hit it with rustoleum after it's turned down a bit.

John from MD · Mar 2, 2019

A machinist can knock that out in a couple of minutes. Check the yellow pages for small fabrication companies, they may be able to give you walk in service.

Modifying an Uzi Barrel

The #1 community for Gun Owners of the Northeast

Member Benefits:

Expendables

Active Member

jjones88

Active Member

John from MD

American Patriot

Users who are viewing this thread

Latest posts

Forum statistics

Latest threads

Forum statistics

Share this page