Mark K
Active Member
The P290 RS has a very sharp-edged, squared-off slide-stop notch:
The edge of the thumbnail on my left (support) hand rests just below the slide stop. Twice now when shooting, the corner of the front edge of the slide-stop notch has torn into the top of my thumbnail when recoiling. Extremely painful.
I'd like to take a Dremel to it and relieve/bevel the front edge of the slide-stop notch a bit, to prevent this from happening (or at least not so bad).
Any issue that I'd cause structural issues to the slide?
The edge of the thumbnail on my left (support) hand rests just below the slide stop. Twice now when shooting, the corner of the front edge of the slide-stop notch has torn into the top of my thumbnail when recoiling. Extremely painful.
I'd like to take a Dremel to it and relieve/bevel the front edge of the slide-stop notch a bit, to prevent this from happening (or at least not so bad).
Any issue that I'd cause structural issues to the slide?
Last edited: