Can it be done? I used the kinetic hammer puller and it works on plain rounds but the gas check is not coming out. Anyone got a plan for this one or just shoot all the bad rounds?
Push it into the case a little and you should be able to grab it with tweezers and pull it back out. It can be put back on the bullet and used if you are careful.
Can it be done? I used the kinetic hammer puller and it works on plain rounds but the gas check is not coming out. Anyone got a plan for this one or just shoot all the bad rounds?
It is real easy. Push on one side and it will pivot upward then use a slim needle nose to remove the gas checks. I have done thousands this way and have learned not to load too many until I find the right load.