6/3 Carry Handle and Dissipator Rifles

dreadpirate · Feb 11, 2018

Might be a stupid question; To use the standard Army 25/300 meter zero, the shooter is supposed to set the drum on the rear sight all the way down for a 14.5" or 16" rifle, and to the "z" mark for a 20" rifle. I am assuming that a dissipator rifle with the same sight radius as a 20" would also use the "z" mark, correct?

dreadpirate · Feb 11, 2018

OBTW - here is a really good read on using carry handle sights on an AR, and what got me thinking about this:

https://savannaharsenal.com/2017/04/08/how-to-zero-ar-15-a2-type-sights/

Huckleberry · Feb 11, 2018

Dissipator are 16” barrels with a full site radius so I used my service rifle zero on my Bushie.

Biggfoot44 · Feb 12, 2018

Full length sight radius , but 16in velocity. So probably won't align perfectly with either.

dreadpirate · Feb 12, 2018

Biggfoot44 said:
Full length sight radius , but 16in velocity. So probably won't align perfectly with either.

I wondered that myself, but would it not be closer to the 20" rifle?

jrumann59 · Feb 15, 2018

I would SWAG it a little based on the FPS. 16" setting on the rear and adjust as needed. But really depends what distances are you going out to? inside 100 yards i doubt standard 16" setting and an adjusted 16" setting would be too far off that it would be noticeable.

6/3 Carry Handle and Dissipator Rifles

The #1 community for Gun Owners of the Northeast

Member Benefits:

dreadpirate

Ultimate Member

Attachments

dreadpirate

Ultimate Member

Huckleberry

No One of Consequence

Biggfoot44

Ultimate Member

dreadpirate

Ultimate Member

jrumann59

DILLIGAF

Users who are viewing this thread

Latest posts

Forum statistics

Latest threads

Forum statistics

Share this page