Sledgehammer45
Member
- Oct 4, 2017
- 58
I've done a previous 80% build a couple years ago and it turned out fine. This current one however is giving me some trouble. Two questions for y'all:
1) After completing the drilling and milling for the FCG and attempting install, the hammer does not make contact or engage with the sear. I thought the pin holes might be in the wrong place but after using some JB weld and re-drilling, there is no noticeable difference in hole location. I think I may have gone too deep but some other forums say that shouldn't be an issue....
2) How should the safety selector interact with the FCG once they're both installed? Without putting the detent spring in but having the FCG installed, the safety seems to not be making contact with the FCG.
Thanks
Sledgehammer
1) After completing the drilling and milling for the FCG and attempting install, the hammer does not make contact or engage with the sear. I thought the pin holes might be in the wrong place but after using some JB weld and re-drilling, there is no noticeable difference in hole location. I think I may have gone too deep but some other forums say that shouldn't be an issue....
2) How should the safety selector interact with the FCG once they're both installed? Without putting the detent spring in but having the FCG installed, the safety seems to not be making contact with the FCG.
Thanks
Sledgehammer