I had 2 roof fans installed and need them wired to the panel. I was going to do it but it requires MC cable. I have the 20A breaker for the panel. Job is in Middletown, MD.
Barter Electric Work for Powder Coating
- Thread starter t84a
- Start date
The #1 community for Gun Owners of the Northeast
Member Benefits:
No ad networks! Discuss all aspects of firearm ownership Discuss anti-gun legislation Buy, sell, and trade in the classified section Chat with Local gun shops, ranges, trainers & other businesses Discover free outdoor shooting areas View up to date on firearm-related events Share photos & video with other members ...and so much more!
Member Benefits:
So no wiring has been done at all? How long of a run and how many walls (floors) to go thru the panel?
This is a cake job. I don't have the mc cable cutter and don't feel real comfortable opening up the panel. Go across the attic and down through an existing opening in the ceiling down to the panel. Probably about a 50-60 ft run. I've already joined the fans into a junction box but used nm cable. I'm not sure if that should be replaced with mc. Is mc for impact protection or something else?
madmantrapper
Ultimate Member
Who said it has to be MC, romex should be fine.
Inspector.
Pretty typical in commercial shops. That and/or EMT.
Can you use EMT? That's pretty easy to use.
Users who are viewing this thread
Latest posts
Forum statistics
Latest threads
-
-
-
Hair-trigger posting... please include more than just the "headline" (1 Viewer)- Started by Mr H
- Replies: 11
-
-
-
(Duplicate - mods please close) MoCo trans student arrested for threatening school- Started by Lafayette
- Replies: 2
-
