I'm looking for a Griffin Armament taper mount direct thread adapter if anyone has one they want to get rid of.
Sorry, I don’t think I was clear. What I meant was screw a GA muzzle device with the correct thread pitch into the can and leave it there unless you want to change thread pitches. It’s almost exactly the same thing as a direct thread adapter. Since you’re changing thread pitches from probably 5/8x24 to 1/2x28 I assume, you’d need an additional muzzle device for whichever ones are not the thread pitch you already have.
Incidentally GA has a very generous discount for honorably discharged veterans, so it may not cost as much as you’d think.
https://www.griffinarmament.com/mount-adapter-driver/
This can be used to assist in removing the muzzle device from the can.
They should have sent you a discount code that applies to accessories. I know, because I own a lot of GA stuff.I know it works for cans but not for accessories. Once you are vetted, when you open up a can page, it applies the discount. It doesn't do that for any of the accessories.
Yes, I understand what you are saying. What I am telling you is that in addition to the price changes in your account, which are automatic once you are registered with the program, you should have also received a code from Griffin Armament for use with accessories that you have to use when you check out. The discount for accessories is not automatically applied. You have to use it every time you buy stuff.As I said before, when I select a silencer, it gives me a discount. It does not give me a discount for accessories.
Yes, I understand what you are saying. What I am telling you is that in addition to the price changes in your account, which are automatic once you are registered with the program, you should have also received a code from Griffin Armament for use with accessories that you have to use when you check out. The discount for accessories is not automatically applied. You have to use it every time you buy stuff.
At any rate, I am attempting to be helpful, but am getting the impression that you are not viewing my posts in your thread as helpful. If that is indeed the case, my apologies and good luck locating the direct thread adapters you are looking for.
Understood, no worries. Just wanted to make sure I wasn’t overstaying my welcome.Don't take short sentences for not appreciating your help. I could not have gotten this far without your help. I type with two fingers and try not to use more words than I can get away with.
I did not receive a code with any of the three messages that were sent to me. She just told me that she applied the discount to my account.
Understood, no worries. Just wanted to make sure I wasn’t overstaying my welcome.