I have gotten some much info on this site. I thought I would pass some stuff I made and use for tumbling brass.
It’s cheap and easy.
I have done thousands of brass using this method.
Total if bought new is $40
First you need a ice maker.
Second you need 2.5 lbs of stainless stee media
Third you need a plastic colender.
You get the ice cream make for cheap and used
The strainer you can find one at goodwill for $1
The media I bout at STM for $20 shipped
I have ran the ice cream maker for 8 hours without any issues.
I tumbled about 500 pieces of 9 mm brass at a time.
I used a cap full of armor all car wash. I don’t like dawn.
I use a half teaspoon of lemishine.
I put the brass and media in and fill the container half full.
I lay the ice cream maker on a 45 degree angle.
Plug it in and walk away.
One in a while I will have some water leaking.
Here are some pics of it.
It’s cheap and easy.
I have done thousands of brass using this method.
Total if bought new is $40
First you need a ice maker.
Second you need 2.5 lbs of stainless stee media
Third you need a plastic colender.
You get the ice cream make for cheap and used
The strainer you can find one at goodwill for $1
The media I bout at STM for $20 shipped
I have ran the ice cream maker for 8 hours without any issues.
I tumbled about 500 pieces of 9 mm brass at a time.
I used a cap full of armor all car wash. I don’t like dawn.
I use a half teaspoon of lemishine.
I put the brass and media in and fill the container half full.
I lay the ice cream maker on a 45 degree angle.
Plug it in and walk away.
One in a while I will have some water leaking.
Here are some pics of it.
Attachments
-
D450AD1A-04FE-490C-880C-E33722C63045.jpg52 KB · Views: 128
-
BE6906AA-D76D-4298-8704-4BCB56160025.jpg79.3 KB · Views: 128
-
D0CA2268-0B87-48EE-BB08-DE560830CB78.jpg59.3 KB · Views: 127
-
1CC1B278-CB52-4CEF-938C-14238F8C9F9C.jpg45.1 KB · Views: 126
-
36095CDA-8503-48C2-821B-6C889F42B3AF.jpg65.1 KB · Views: 123
-
EF69E233-43B7-4C80-A85E-23DA57446C3B.jpg117.3 KB · Views: 127