My Toy
Ultimate Member
Started to use some of the old Glock ten round mags that I have had for years.The pistol I'm shooting is a Polymer80 940 compact (same size as the Glock 19). Except for the Polymer80 frame the whole rest of the pistol is factory Glock with a complete factory Glock Gen 3 upper.
I was shooting handloaded 9mm with Berry's 124 gr flat point. The first 9 rds feed beautifully but the last round approx. 25% of the time hung up on the bottom of the barrel's feed ramp.
The followers in my older Glock 10 rd magazines are marked 2183-1. I bought a couple of new Glock 10 rd mags that seem to have a stiffer spring and a follower with the number 2183 on the flat surface and a number 2 on the surface of the follower that engages the slide release. These newer mags work a little better but still the occasional FTF the last round in the mag.
I searched the web and there were a number of posts (on other forums) from years ago about Glock 9mm 10 rd mags notoriously having problems with FTF last round of FP/HP ammo. There was discussion of the original follower (2183) and some newer versions that were dash 2 and dash 3. However there seemed to be problems with all of them.
Anyone here experienced the same problem and how did you solve the last round failure to feed out of a Glock 10 rd mag. It appears that the follower feeding the last round nose dives and the bullet gets stuck on the bottom edge of the feed ramp.
I was shooting handloaded 9mm with Berry's 124 gr flat point. The first 9 rds feed beautifully but the last round approx. 25% of the time hung up on the bottom of the barrel's feed ramp.
The followers in my older Glock 10 rd magazines are marked 2183-1. I bought a couple of new Glock 10 rd mags that seem to have a stiffer spring and a follower with the number 2183 on the flat surface and a number 2 on the surface of the follower that engages the slide release. These newer mags work a little better but still the occasional FTF the last round in the mag.
I searched the web and there were a number of posts (on other forums) from years ago about Glock 9mm 10 rd mags notoriously having problems with FTF last round of FP/HP ammo. There was discussion of the original follower (2183) and some newer versions that were dash 2 and dash 3. However there seemed to be problems with all of them.
Anyone here experienced the same problem and how did you solve the last round failure to feed out of a Glock 10 rd mag. It appears that the follower feeding the last round nose dives and the bullet gets stuck on the bottom edge of the feed ramp.