I have a red dot and iron sights on a piston rifle. I have used both together and separately. Both were zeroed in separately. Took it out to the range last week and then cleaned it the next day. Without thinking I took off the front iron sight and cleaned the area under it. The piston makes a pretty big mess right where the front iron sight is.
Will I need to re-zero the darn thing? I made this mistake in the past with the red dot and that thing was way off when I put it back on. I haven't touched it since. Can't believe I made the same stupid mistake. However, it seems like the front iron sight only has a few adjustment notches vs virtually infinite with the red dot.
Guess I shouldn't rely on it till I shoot it again.
Will I need to re-zero the darn thing? I made this mistake in the past with the red dot and that thing was way off when I put it back on. I haven't touched it since. Can't believe I made the same stupid mistake. However, it seems like the front iron sight only has a few adjustment notches vs virtually infinite with the red dot.
Guess I shouldn't rely on it till I shoot it again.