I have an Anderson AM10 rifle. Went to the range this weekend and when I took it down to clean, the bolt carrier release button FELL OUT. I looked closer and there is a hole in the receiver that accepts a screw or pin to hold it in place. The spring is still in place and when I reassemble the button it stays In place and functions. I looked everywhere and am unable to find the fastener, so I need to purchase a replacement.
1. Does anyone know what the spec is for this part? roll pin or screw? Sive? thread pitch?
2. I contacted the manufacturer but so far have received no reply. Also, their website does not list parts that specific, only group kits for someone building a rifle, upper, lower, ETC.
At this point I am at a loss as to where to go to resolve my dilemma. Also, Brownells does not have any components parts for this specific platform.
1. Does anyone know what the spec is for this part? roll pin or screw? Sive? thread pitch?
2. I contacted the manufacturer but so far have received no reply. Also, their website does not list parts that specific, only group kits for someone building a rifle, upper, lower, ETC.
At this point I am at a loss as to where to go to resolve my dilemma. Also, Brownells does not have any components parts for this specific platform.