ZT351TS some 1/4" 2x2 G10, a strip of 6.4 Ti, #2 hardware, a dremel to shape the grip and a torch to bend the clip. All I really wanted was a deep carry clip for my ZT351. I couldn't find a maker anywhere so it snowballed a little.
If you like the "wave" feature, you can take the two on top in your photo and put a small plastic zip-tie in the thumb hole, works quite well for me...My EDC rotation....
VERY NICE BLADE!!
I have been thinking about fashioning something like this for my 0350TS, I just don't like the factory clip. Would you think about fashioning and selling deep pocket clips?
Also, where did you get aftermarket scales?
Mostly cheap playthings, however, the boot knife (upper left) was always in my flight boots during many years as Navy flyer, and the issue survival knife (upper right) I'm pretty fond of too. My favorite is the K-Bar, nearly bottom-center.
I first tried to make a clip out of a spare steel Spyderco clip. Burned it up like a matchstick with the torch. Thankfully, the 6/4 Ti blank from USKnifemaker.com took much better to bending with heat. Try it yourself. Mangle it and your only out $4.