daNattyFatty
Ultimate Member
Good morning all!
So, I'm about to order a SLR Sentry 6 to go on my 11.5" BCM upper (which I intend to shoot suppressed most of the time) and have a few questions about installation and testing.
I'm under the impression that my barrel is already dimpled (that'll obviously be verified once I take the current gas block off). Does anyone know if the set screw location on the SLR should match up with the current dimple and gas port? Secondly, once I have the new block installed, I want to test for function before using Rocksett on the set screw. Will I be okay with just hand tightening the set screw to get the gas setting correct and verify that the block is in the correct position, relative to the gas port? This would be my first time installing a gas block and I want to make sure all is well before I do a second dimple and pin it.
So, I'm about to order a SLR Sentry 6 to go on my 11.5" BCM upper (which I intend to shoot suppressed most of the time) and have a few questions about installation and testing.
I'm under the impression that my barrel is already dimpled (that'll obviously be verified once I take the current gas block off). Does anyone know if the set screw location on the SLR should match up with the current dimple and gas port? Secondly, once I have the new block installed, I want to test for function before using Rocksett on the set screw. Will I be okay with just hand tightening the set screw to get the gas setting correct and verify that the block is in the correct position, relative to the gas port? This would be my first time installing a gas block and I want to make sure all is well before I do a second dimple and pin it.