GeorgeSSR
Active Member
- Jan 31, 2009
- 196
Any recommendations for people/businesses for getting a small part fabricated? I need to get a gas block bushing made with no gas hole that would essentially turn a Ruger into a straight pull rifle.
In case you're curious I have a Ceiner conversion kit (straight blowback) in a stock that requires complete disassembly to convert the thing between 22LR and .223, and since the cleaning method to blow out the dirt from 22LR is to dump a mag of .223 I might as well modify this thing so it doesn't need to be disassembled every 200 rounds. Putting a plug in there is more convenient as there's no extra work involved in conversion, and if I don't convert it too often I don't gunk/wear out the parts from frequent disassembly. Currently I have the gas tube turned around and bushing removed so the only thing I have to clean is the gas port on the barrel and the space where the bushing sits (where it can easily be cleaned by a drill bit spun by fingers only).
In case you're curious I have a Ceiner conversion kit (straight blowback) in a stock that requires complete disassembly to convert the thing between 22LR and .223, and since the cleaning method to blow out the dirt from 22LR is to dump a mag of .223 I might as well modify this thing so it doesn't need to be disassembled every 200 rounds. Putting a plug in there is more convenient as there's no extra work involved in conversion, and if I don't convert it too often I don't gunk/wear out the parts from frequent disassembly. Currently I have the gas tube turned around and bushing removed so the only thing I have to clean is the gas port on the barrel and the space where the bushing sits (where it can easily be cleaned by a drill bit spun by fingers only).