cyrano_oneone
Active Member
Ok...need help 80% lower
I think I am doing this right...instead of starting a new thread I am continuing an older one.
I am working on an 80% lower. Pretty interesting stuff. I am making quite the mess with a borrowed drill press. So far what I have is pretty crude looking...but I am learning stuff.
My question is drilling holes. I read somewhere you cannot drill a precision hole. You need to drill a smaller hold a ream it.
I am about to drill the safety hole...It is a 3/8" hole.
Should I drill with a smaller size and ream the hole? What should the small size be?
or
Are people just drilling 3/8" hole with no reaming?
thanks
Jon
I think I am doing this right...instead of starting a new thread I am continuing an older one.
I am working on an 80% lower. Pretty interesting stuff. I am making quite the mess with a borrowed drill press. So far what I have is pretty crude looking...but I am learning stuff.
My question is drilling holes. I read somewhere you cannot drill a precision hole. You need to drill a smaller hold a ream it.
I am about to drill the safety hole...It is a 3/8" hole.
Should I drill with a smaller size and ream the hole? What should the small size be?
or
Are people just drilling 3/8" hole with no reaming?
thanks
Jon