I know the AR9 questions come up all the time, but in my search I didn't really find what I was looking for. Rather than revive an old thread, I'll just start another.
I'm hoping to finish up my first AR9 pistol build. I've got a spikes lower with an SB PDW Brace, and 3 EndoMags that I can't...
Any IP's have one in stock? Looking for the full size with the 5" barrel. Definitely want the single stack and I'd prefer the model with the rail, but I'm also open to no rail.
I'm pretty fresh into loading and I've been as cautious as possible with each step. From used brass to loaded, these are the steps I've been doing:
1) Sort cases by caliber
2) Tumble for a couple hours in crushed walnut from Petco
3) Sift media and lube clean cases
4) Run through sizing and...
I recently acquired a Remington 700 that I know nothing about. My brother in law got his PCS and is going overseas for 3 years so I decided to take it off his hands. It is chambered in .308, its got a 6-24 scope, and is sitting in a Choate Ultimate Sniper Stock.
Do any of you recognize the...
So I've had my 550B for over a year now, but just got a case trimmer for Christmas. I've definitely not gotten my moneys worth over the past year because anytime a case measured over 1.760 I set it aside until I was able to trim it.
Now that I have the trimmer I've found different reports...
I ordered my fiance's father a new 870 for Christmas. He's very into the Tacticool look so I picked him up the Express Tactical.
He's going to use it primarily as a bedside gun and I figure I'll pick up a TLR-1 HP. Two questions about the light:
1. Is a remote switch a good idea? I'd...
I bought a few 30rd Pmags at the Chantilly show and I intend to put on ranger plates for the Tacti-cool appearance.
Would putting the new baseplates be considered Manufacturing a 30rd magazine? If so, is it also a problem taking them appart to clean them and then reassemble them?
I am just...
I have a birth defect on my right hand. My middle finger was removed at birth due to no Proximal Phalange present. My Pointer finger has a joint that is permanently bent, My middle finger is 1.5 times as thick as a normal finger, and my pinky is aimed at the 3:00 position rather than pointing...
First off, I have ZERO experience with the internals of any firearm. I've never broken down any gun beyond just a simple field strip. I ordered the Ambi-Safety when I bought the gun. Living in MD, I had plenty of time for it to get here before I actually got to take the pistol home. I just...