Years ago when I was purchasing an Octane 45, I saw a video that using a 9mm end cap made it work better with 9mm.
Unfortnately, SilencerCO had stopped selling the 9mm end caps.
Fast-forward to now, and I see on Silencer Co website they sell end caps for many of their supressors, but not for...
DWELL TIME
A 20.0 inch barrel - the distance from the gas tube to the muzzle is about 7 inches.
A 10.5 inch barrel - the distance from the gas tube to the muzzle is about 3 inches.
With this load of HERCO powder, in the 10.5 inch barrel, the muzzle pressures are roughly the same as standard...
I have a new 10.5 inch 5.56 upper from PSA for my pistol lower.
I have been playing with Quickload to find a way to have NO flash, No super loudness or percussion from the short 10.5 inch barrel.
Flash comes from unburned powder in a standard 5.56 round.
Excessive loudness is from the...
In November I purchased 9 pounds of CFEBLK powder from Midway.
However, I am not so sure it is the best choice for 7.62x39 so I might sell it for what it cost me.
What experiences do people have with CFEBLK ?
I just opened another box in the basement.....more Orlite Magazines.
I have 40 of them. Some have the price sticker on them.
In the 1980s I purchased 40 of these for around $14.50 each.
What was I thinking?
Selling them on gunbroker sounds like a good idea. Probably best to wait until after the election - might go up in value depending who wins.
Here is another question:
Can I sell them to someone in another state via the internet, and then mail it to them from a Maryland post office? Or do...
Hi,
I was recently going through my old stored stuff, and found two dozen Orlite 30 round AR magazines.
I purchased these in the 1980s, and to my recollection they worked reliably. Back then, I had filed off the skirts so it would fit into my rifle. The skirts was to prevent sand or dirt...