350 Legend Subsonic

[Susquehannabum]

Anybody loading 350 Legend with a 200 grain bullet subsonic?
Not a lot of info out there on powders.

 

[guzma393]

Anybody loading 350 Legend with a 200 grain bullet subsonic?

Not a lot of info out there on powders.

Dabbled a bit in it using imr4227 and the lee 358/200 grain gas checked and powder coated bullet. Loaded for a boltgun though, so not sure if they run on a AR.

Sent from my Moto G (5) Plus using Tapatalk

 

[Susquehannabum]

I'm loading for a bolt gun also. Being such a new cartridge, there is not a lot of loading data out there. I have some 2400, Bullseye, H110 and Lil' Gun to work with. H110 and Lil'Gun are not good for reduced loads. Trying to find a safe load.

 

[teratos]

I'm loading for a bolt gun also. Being such a new cartridge, there is not a lot of loading data out there. I have some 2400, Bullseye, H110 and Lil' Gun to work with. H110 and Lil'Gun are not good for reduced loads. Trying to find a safe load.

I’ve used H110 and Lil Gun in .300 BLK subs with success. 220-240 grain projectiles. Cycles fine. Something like 10.5 grains Lil gun is where I landed on those with 220 grain leatherhead bullets. Should be great in a bolt gun.

 

[guzma393]

https://castboolits.gunloads.com/sh...ced-loads-for-350-legend&highlight=350+legend

Here is my post on cast boolits. Alot of users posted their reduced loads. In addition, here is a popular thread about cast bullet reduced loads. I'm sure you'll find some leads of subsonic load data in it:

https://castboolits.gunloads.com/sh...-Legend-and-Cast-Boolits&highlight=350+legend

 

[guzma393]

I’ve used H110 and Lil Gun in .300 BLK subs with success. 220-240 grain projectiles. Cycles fine. Something like 10.5 grains Lil gun is where I landed on those with 220 grain leatherhead bullets. Should be great in a bolt gun.

Lil'gun does some weird things (incomplete burn, pressure spikes) when loaded below the starting load. It's forgiving for 300 blk since the case capacity is alot smaller than 350L. I wouldn't recommend using lil'gun for reduced loads for 350L. I never worked with h110, but i assume it might be a similar case.

 

[teratos]

Lil'gun does some weird things when loaded below the starting load. It's forgiving for 300 blk since the case capacity is alot smaller than 350L. I wouldn't recommend using lil'gun for reduced loads for 350L. I never worked with h110, but i assume it might be a similar case.

Ah. Good to know. Thank you!

 

[atblis]

Anybody seen the Winchester 255 gr for sale as components?

 

[Melnic]

It would be good to see if Trailboss worked out for subs. I"ve used Trailboss in 308 subsonic.

 

[Susquehannabum]

I've read everything I could find on the CB site about sub loads in 350L. Of course I have plenty of the not recommended powder. H110 and Lil'Gun. Looks like Norma 200 is very good for sub loads but it's impossible to find right now.
I have a whole 8lb jug of Bullseye and some 2400. I'm hoping to find someone that has tried one of them.

 

[Biggfoot44]

Extrapolating from .357 Max , 2400 should work .

 

[Susquehannabum]

I think 2400 would work also. I used it in 44 Mag and 22 Hornet in the past. Would like to see some published data before loading some up.

 

[Seabee]

Lil'gun does some weird things (incomplete burn, pressure spikes) when loaded below the starting load. It's forgiving for 300 blk since the case capacity is alot smaller than 350L. I wouldn't recommend using lil'gun for reduced loads for 350L. I never worked with h110, but i assume it might be a similar case.

^^^this