jimbobborg
Oddball caliber fan
Story:
I bought a barrel with no pin cuts so I could have it cut down, threaded, have a FSB installed on it, install and pin a Flaming Pig (he had 3 at the time) and put it all together by a smith here who does this. That was in April. Fast forward to July, I call him up asking about my stuff. He says since the FSB is already drilled, it's not going to work, and he's going to get a virgin FSB so he can do the job, no extra cost since he didn't tell me about needing a non-cut FSB. He does the fitting in batches, so once he got to the next batch, he'd get the upper done. Fast forward to two weeks ago. I call up, he seems to have forgotten about my upper, and he didn't put a Flaming Pig aside for me like he said he would. He said he'd have it all done by the end of last week and would call me when it's done. It's now Christmas, no call, no upper. I'm thinking of pulling my stuff out of his shop and going somewhere else. Where can I get a FSB that isn't pre-drilled so I can get this done by someone competent? And is Noveske still making Flaming Pigs?
I bought a barrel with no pin cuts so I could have it cut down, threaded, have a FSB installed on it, install and pin a Flaming Pig (he had 3 at the time) and put it all together by a smith here who does this. That was in April. Fast forward to July, I call him up asking about my stuff. He says since the FSB is already drilled, it's not going to work, and he's going to get a virgin FSB so he can do the job, no extra cost since he didn't tell me about needing a non-cut FSB. He does the fitting in batches, so once he got to the next batch, he'd get the upper done. Fast forward to two weeks ago. I call up, he seems to have forgotten about my upper, and he didn't put a Flaming Pig aside for me like he said he would. He said he'd have it all done by the end of last week and would call me when it's done. It's now Christmas, no call, no upper. I'm thinking of pulling my stuff out of his shop and going somewhere else. Where can I get a FSB that isn't pre-drilled so I can get this done by someone competent? And is Noveske still making Flaming Pigs?