ibanez320dx
New guy.
They have lowers back in stock.
Has anyone use dremel if so what what bits did u use?
Has anyone use dremel if so what what bits did u use?
I have a question, as I have just only ordered my EP Lower but have looked at pictures on google would it be possible to just drill down the sides (where the ribs are) and remove the injection form by pulling it out?
I looked at the pictures of the clear model not quite in production and it seems as though that might be a possibility. I was just wondering, I do have the tools to clean it out either way. Thanks
Ordered last night. Looking forward to completing it.
Fox,
The actual link for the blemished lowers is below, however, I don't know if you can access/see it if you haven't "like" EP Lowers on Facebook.
http://www.eparmory.com/product-p/blem-units.htm
Is anyone else having problems with the Hammer pin location? I am now under the impression that my hammer pin hole guide is off. It appears to be too far back to correctly align the hammer for its engagement with the trigger. I'll PM EP Lowers on this as well but didn't know if anyone else had the problem?
I want to get a pink one for my GF...what would be the proper procedure to give it to her so she could own it all legal-like after 10/1 rolls around, assuming that I would be doing all the finishing and assembly?