I have a quick question as I endeavor through this.
I installed the lower parts kit and I want to make sure I did it right.
When the hammer is uncocked, the safety switch an only be switched to Fire. While uncocked, it wil point at fire and is capable of moving only to about the 11o'clock position.
However, when the hammer is back I can freely switch back and forth from 9 to 12 (safety to fire).
Is this normal?
I have pictures if needed.
I installed the lower parts kit and I want to make sure I did it right.
When the hammer is uncocked, the safety switch an only be switched to Fire. While uncocked, it wil point at fire and is capable of moving only to about the 11o'clock position.
However, when the hammer is back I can freely switch back and forth from 9 to 12 (safety to fire).
Is this normal?
I have pictures if needed.